osteel's blog Web development resources

Blog category

Install and deploy a Pelican blog using Fabric - Part 4: workflow, extras and conclusion

Alright! This was a bit of a long road, but we are finally getting there. In the previous part, we used Fabric to fully provision a server and pull our content from a Git repository. In this fourth and last part, we are going to review a complete worklow, take a few extra steps to complete our blog and conclude our journey.

Install and deploy a Pelican blog using Fabric - Part 3: Fabric

In part 2, we covered the installation and configuration of Pelican in our local environment. It is now time to provision our server and publish content using Fabric.

Install and deploy a Pelican blog using Fabric - Part 2: installation and configuration

In part 1, we set up a local environment containing everything Pelican requires to run properly. Let's move on to the installation and configuration of Pelican itself.

Install and deploy a Pelican blog using Fabric - Part 1: local environment

This series of articles will walk you through the different steps to install, setup and deploy your first Pelican blog (just like this one).